1991 DODGE DAYTONA 2DR HATCHBACK
Security
Battery PNK/BLK OR + (+) RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) DRIVER'S KICK PANEL
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN/ORN(-) DRIVER'S KICK
ParkingLights BLK/YEL(+) (+) DRIVER'S KICK PANEL OR FUSEBOX
Remote Start
Battery PNK/BLK OR + (+) RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BRN/YEL (-) AT SWITCH
Tach BLK/GRY (-) (-) AT COIL
SpeedSense WHT/ORN (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BLK/YEL(+) (+) DRIVER'S KICK PANEL OR FUSEBOX
BrakeLights WHT/TAN (+) AT BRAKE SWITCH
ReverseLights VIO (+) AT SWITCH
Horn DK.GRN/RED AT FUSEBOX "HORN RELAY"
Doorlocks / Window
PowerUnLock PNK/VIO (REV) REVERSE POLARITY
PowerLock ORN (REV) DRIVER'S KICK PANEL
Convenience
HeadLights VIO (+) AT FUSEBOX "#17"
LowSpeedWipers BRN/WHT (+) AT WIPER SWITCH
TrunkRelease MANUAL RELEASE
Mobile Audio / Video
Battery PNK/BLK OR + (+) RED IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg GRN/YEL
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg VIOLET/YELLOW
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg BRN/YEL
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
